LED Wall Washer transparent adhesive glue | transparent adhesive glue Zhejiang quality assurance Product Description: This product is made of high quality raw materials developed by a cold-curing two-component condensation-type silicone; when the two components in a certain weight ratio or when the volume mixing ratio, a mixture of experience cured at room temperature for high-performance elastomer; no obvious material curing shrinkage and temperature; compound non-toxic, non-corrosive; UV resistant material fully cured, the anti-aging properties good, excellent hydrophobicity, with excellent weather resistance, to maintain elasticity in the range of -40 ~ 200 ° C, excellent insulating properties. The series is a two-component condensation-type silicone, can be cured at room temperature, ethanol molecules released during the curing of the PC, PP, ABS, PVC, copper and other materials will not cause corrosion; for most of the electronic parts and materials (PP, except PE) good adhesion. Features: ◆ low viscosity, good fluidity ◆ excellent adhesion, moisture-proof waterproof outdoor effect of excellence ◆ transparent non-yellowing, excellent light transmission ◆ High insulation, potting product work stable after ◆ has dismountability, sealed components can be removed for repair and replacement of rubber material ◆ non-toxic, non-corrosive; UV resistant material fully cured, the anti-aging properties Good Typical applications: ◆ LED outdoor display, digital control, pixel tube light bar ◆ ◆ Optical high light transmission parts sealing technology parameters: No. Test Test Result Appearance (after curing) Transparent 2 Viscosity (mPa s, mixed?) 1000 ± 300 3 Density (g / cm3) 0.95-0.98 5 Dry time (min , 25 ℃) 40-50 6 hardness (Shore A) 10-20 7 Tear strength (MPa) 0.2 8 Tensile strength (MPa) 0.2 9 Elongation (%) ≥100 10 Dielectric strength (KV / mm) ≥18 11 Volume resistivity (Ω cm?) 1.0 × 1014 (Note: The dry time (ASTM American Standard) refers to the 25 ℃, 80% relative humidity in a specific time sizing, with a smooth round of light contact with the surface of the glass rod sizing, round glass rod leaving the sizing surface without leaving adhesive residue, called the surface dry.)