Electronic component adhesive glue good quality fixed | Shenzhen anti-yellowing adhesive glue fixed purchase a product description of this product can be combined at room temperature and moisture in the air to cause crosslinking, curing become high-performance elastomer, is an excellent metal and non-metallic materials, adhesives and fixed plastic. The series can be rapid bonding, curing materials no obvious shrinkage and temperature rise. Rubber non-toxic, non-corrosive; good elasticity and toughness Colloid completely cured after fatigue, can take advantage of the excellent electrical properties of silicone materials to maintain elasticity in the range of -60 ~ 200 ° C. The series is a one-component, paste, alcohol type RTV silicone rubber, the curing process to release alcohols, copper and polycarbonate (PC) and other non-corrosive material, in full compliance with the EU RoHS directive. Second, product characteristics ◆ Table dry fast, fast curing ◆ aluminum, copper, stainless steel and other metal adhesion ◆ better elasticity and toughness, resistance to yellowing ◆ excellent electrical properties, fight through excellent performance ◆ moisture, shock, corona resistant, anti-leakage Third, the main purpose ◆ ◆ high-end fixtures adhesive sealing adhesive seal ◆ shade of vehicle electronic components quickly locate and appliances panel bonding adhesive sealing ◆ Fourth, technical indicators for each performance specification table below based on measured values ??are lower and leave a sufficient margin determined. No. Test items found 1 2 Appearance White paste Density (g / cm3) 1.20-1.40 3 dry time (min, 25 ℃) 3-10 4 Temperature (℃) -60 ~ 200 5 hardness (Shore A) 20 -306 Tensile strength (MPa) ≥1.8 7 Elongation (%) ≥300 8 dielectric constant (1.2MHZ) 2.6-2.8 9 dielectric strength (KV / mm) ≥20 10 Volume resistivity (Ω? cm ) 1.0 × 1014 (Note: The dry time (ASTM American Standard) means: at 25 ℃, 80% relative humidity, specific time sizing, the glass rod with a smooth round light contact surface sizing, Round glass rod leaving the sizing surface without leaving adhesive residue, called table dry.)